EBMM Stingray bass green
Results 1 to 6 of 6

Thread: JP6 Splitting pickups / Replacing pots

  1. #1

    User Info Menu

    Question JP6 Splitting pickups / Replacing pots

    Hello,

    I recently bought a 2003 JP6 that it's a little banged up on the electronics, the pots are kinda rusty with some white dust dried over them, I think it's possible to perform a chemical cleaning and make them new again but I was just thinking about either installing a no load tone on the tone pot to bypass the signal when at 10, or install a push pull pot so I could split the pickups in all positions. The pickup switch is also a little loose.

    I sent a message to customer support asking for some help and cost etc but since I dont live in the US until I get the components that would take some time so I thought about taking the guitar to a professional guitar tech that I know and replace the volume and tone pots (no piezo) for whatever he does have in his store, probably CTS since it's a top tier tech.

    I know the pickup switch is a little specific and uses a proprietary board so I would replace it with an original provided by EBMM later but regarding the pots, does anyone know if there is any possible problem with fit or wiring using something different than the ones that come from factory?

    Thanks,

  2. #2

    User Info Menu

    Do they sound scratchy? Or just look bad? Pots are pots, so no problem there, provided you get the right resistance and taper. But you can probably bring them back with some Deoxit, so I'd try that first.
    Last edited by beej; 04-10-2017 at 07:16 PM.

  3. #3

    User Info Menu

    Here is a write up on splitting coils...on my bucket list to do...

    http://http://forums.ernieball.com/e...installed.html

  4. #4

    User Info Menu

    Quote Originally Posted by beej View Post
    Do they sound scratchy? Or just look bad? Pots are pots, so no problem there, provided you get the right resistance and taper. But you can probably bring them back with some Deoxit, so I'd try that first.
    Yeah all electrics are making a little bit of noise so it probably needs some maintenance on this part.

    Still on this topic, it may sound dumb but the knobs are glued or just assembled on the pots, I know it's normally only assembled but I tried to pull them off to see if the rust is only superficial but it was really stuck so I didn't force.

  5. #5

    User Info Menu

    Small allen screw to loosen under the rubber ring.
    Silhouette Special (2005 Buttercream Limited Edition)
    Cutlass HSS (2018 Roasted Special, Ivory White)

    Forum Rules and Useful MM Guitar Info

    Required reading - Forum Decorum

    Ernie Ball Customer Service
    Music Man Customer Service


    An Irishman in Paris, guitar teacher and tech, folder of underpants, stubber of toes.

  6. #6

    User Info Menu

    Quote Originally Posted by DrKev View Post
    Small allen screw to loosen under the rubber ring.
    Thanks

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Ernie Ball Forums