Music Man Modern Classics
Results 1 to 5 of 5

Thread: JP15 back controls

  1. #1

    User Info Menu

    JP15 back controls

    I was checking the controls on the back on my JP15 and they don't actually seem alligned with the holes. What that means, is that it doesn't seem like I can adjust the controls without removing the "casing". Does that sound right?

    if not, should just open and ajust the controls?

    on a second note can adjust the controls with the guitar plugged in?

    lastly, where is the light located,which should light up if the battery is low?

    thanks,

    JP15 back controls-jp15-2-jpg
    JP15 back controls-jp15-jpg

  2. #2

    User Info Menu

    Quote Originally Posted by Pedro Malta View Post
    I was checking the controls on the back on my JP15 and they don't actually seem alligned with the holes. What that means, is that it doesn't seem like I can adjust the controls without removing the "casing". Does that sound right?
    Yes. Would be nice if the holes lined up but 0.5 mm tolerance here and there in the factory and we see why they don't always line up perfectly. Yes, you'll have to open it.

    Quote Originally Posted by Pedro Malta View Post
    if not, should just open and ajust the controls?
    Yes.

    Quote Originally Posted by Pedro Malta View Post
    on a second note can adjust the controls with the guitar plugged in?
    Yes. In fact you should, so you can hear your adjustments.

    Quote Originally Posted by Pedro Malta View Post
    lastly, where is the light located,which should light up if the battery is low?
    There isn't one. (Only on the Petrucci Majesty models) Your ears will tell you when it needs changing.
    Silhouette Special (2005 Buttercream Limited Edition)
    Cutlass HSS (2018 Roasted Special, Ivory White)

    Forum Rules and Useful MM Guitar Info

    Required reading - Forum Decorum

    Ernie Ball Customer Service
    Music Man Customer Service


    An Irishman in Paris, guitar teacher and tech, folder of underpants, stubber of toes.

  3. #3

    User Info Menu

    Is the PCB attached directly to the pots or is there some wiggle room? You could always see if you can shift the controls over a small amount.

    If you have to take off the cover it's not a big deal. Just remember not to over tighten the screws when putting them back on, and to turn the screw backwards a few times to make sure you're engaging the threads into the wood.
    2007 Stingray 5 HS Cherry Burst / Maple FB / 3 Band EQ / Ceramic Pickups
    2012 Stingray 5 H Pearl Blue / Rosewood FB / 3 Band EQ/ AlNiCo Pickup
    2012 Steve Morse Morse Blueburst / Rosewood FB
    2012 Luke III SSH Vintage Sunburst / Rosewood Neck

  4. #4

    User Info Menu

    I looked at this very thing this week. The PC board is attached via two plastic tabs. the tabs don't keep it straight up and down, so, in my JP15 at least, the board is just settled at an angle. you could take some electrical tape and put it on the board at a point that' would be covered by the back plate and tape it to the body under the plate so that it's held close to the body at the back plate is drilled for.
    Balls..... everywhere!

  5. #5

    User Info Menu

    Thanks!

    very good answers!

    I just wanted to make sure I wasn't the only one and this wasn't a "defect".

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Ernie Ball Forums