Ernie Ball Tremolo Pedal
Results 1 to 3 of 3

Thread: Cutlass RS SSS HB swap....

  1. #1

    User Info Menu

    Cutlass RS SSS HB swap....

    If an owner of an SSS cutlass were to buy an extra HB slotted pick guard, and in the interest of easy swapping, 2 extra single coils too, would that owner be forgoing both the silent circuit and the buffer in this new setup?

    Secondarily, If this owner were to simply swap in a HB from another manufacturer, yet retain the original neck and middle single coils, would this owner be able to enjoy the benefits of both buffer and silent circuit systems in all pickup positions as if it were a HSS from the factory, or would this owner be forgoing these systems on the aftermarket HB, yet keep them on 3,4 and 5 positio0ns?

  2. #2

    User Info Menu

    I don't have a schematic or knowledge of what the SSS insides/circuit board look like but based on what I know of how my HSS works here's my two cents...

    We can freely swap and change pickups for anything we like and retain the silent circuit and the buffer. And on my the HSS it seems that the silent cicuit can be adjusted down to zero and therefore can be happily used with hum cancelling pickups if need be. I suspect that the buffer cannot be bypassed if using the stock pots/circuit board though it may be possible to bypass the silent circuit if needed.

    Incidentally, all recent Cutlasses are routed HSS, so you can drop a humbucker in there no problem, though some of the earlier SSS instruments (pre-2018) were routed SSS.

    As always, contact customer service and ask them for a wiring diagram for the SSS version and any advice that they can give you.
    Silhouette Special (2005 Buttercream Limited Edition)
    Cutlass HSS (2018 Roasted Special, Ivory White)

    Forum Rules and Useful MM Guitar Info

    Required reading - Forum Decorum

    Ernie Ball Customer Service
    Music Man Customer Service

    An Irishman in Paris, guitar teacher and tech, folder of underpants, stubber of toes.

  3. #3

    User Info Menu

    this was helpful. I just realized that you wouldn't even need the silent circuit for position 1 anyways, considering a humbucker is already hum canceling. But it sounds like you could use the silent circuit for position 2, and the buffer would still work to match the output between settings. Pretty cool.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Ernie Ball Forums