erickpeniche
New member
- Joined
- Dec 30, 2016
- Messages
- 4
Hi there!
I recently bought a SBMM JP70 and bought the Illuminator 7 pickup set in Black to match the guitar. I've spent some time looking a the diagrams from DiMarzio (Wiring Diagrams | DiMarzio) and reading the 4 Conductor installation instructions (http://www.dimarzio.com/sites/default/files/diagrams/4Conductor.pdf), but I'm very confused on what parts and what diagram to use.
My goal is to have my pickups installed in the same setup as a EBMM JP13. I've haven't seen a wiring diagram for this guitar, the closest thing I've found is the pickup positions and schematics:
And so far to achieve the JP13 setup, I know I need the following parts:
I've looked into the diagrams from DiMarzio going through 2 Pickup Guitar -> 2 Humbucker -> [3 Way | 3 Way 4PDT on-on-on EP1111] and still have no idea which is the correct diagram that I should use.
Does anyone knows which is the exact diagram that I'm looking for? Any help, tip or guidance will be much appreciated.
Thanks
I recently bought a SBMM JP70 and bought the Illuminator 7 pickup set in Black to match the guitar. I've spent some time looking a the diagrams from DiMarzio (Wiring Diagrams | DiMarzio) and reading the 4 Conductor installation instructions (http://www.dimarzio.com/sites/default/files/diagrams/4Conductor.pdf), but I'm very confused on what parts and what diagram to use.
My goal is to have my pickups installed in the same setup as a EBMM JP13. I've haven't seen a wiring diagram for this guitar, the closest thing I've found is the pickup positions and schematics:
And so far to achieve the JP13 setup, I know I need the following parts:
- 3 way 4PDT switch (on/on/on), can be DiMarzio EP1111 (other switches may exist but not sure about if their pin setup is the same)
- 500K Push/Pull or Push/Push(not easy to find) Pot, the recommended from the install instructions is the DiMarzio EP1201PP
- .022 µF capacitor for the tone pot
I've looked into the diagrams from DiMarzio going through 2 Pickup Guitar -> 2 Humbucker -> [3 Way | 3 Way 4PDT on-on-on EP1111] and still have no idea which is the correct diagram that I should use.
Does anyone knows which is the exact diagram that I'm looking for? Any help, tip or guidance will be much appreciated.
Thanks