Volume Pedal Wiring Help needed

[kaioatey]

Hi... I've just rewired my VP Jr to be used in a buffered place on my board. I've also bypassed the circuit board and have wired directly to the input and output jacks. The problem is that the curve of the pot is mostly in the first bit of travel rather than the last bit... Which wires do I switch?
thank you for any help!

 

[beej]

Try reversing input and output and see if that helps. Also, this is the 25k version? With a 250k pedal after a buffer, the taper will be affected.

 

[kaioatey]

Try reversing input and output and see if that helps. Also, this is the 25k version? With a 250k pedal after a buffer, the taper will be affected.

It is the 25K version. I have done as you suggested and it reversed the taper.... that is what I had hoped for, so thank you very much!

 

[beej]

Well there you go Just swap the input & output leads next time you open it up.