Search:

This is a very helpful post thank you!

Hi!

Thank.you for your answer. I'm not very good at spacial location, you say I need to add relief by loosening the truss rod, that means by turning the wheel to the right if I'm facing the...

Hello everyone

I have a EBMM Majesty, it has standard string gauge (10 mm high E) and I have tuned it down to C standard. The tension of the strings has decreased (of course) and I seem to get...

Thank you!

Hi again.

So the guitar is in D tuning now. Do you say that I should start by tightening the springs? I could tighten the springs until E standard but that will make that the bridge sinks into...

Haha well I actually have 2 Majesties lol... One I keep in standard and the other one is supposed to vary in tuning. How do I lock the term block inside the cavity?

Hi!

The gauge of the strings is 10 mm (high E), I don't change the strings when tuning down so it is the same gauge

Hello everyone

Here comes a "dumb" question that I have struggled with.

I have EBMM Majesty but I guess it is the same for every guitar with floating bridge.

When I tune down from standard...

Hi! Thank you for your response. Yes I have tried that, a put some rubber tubes inside of the springs to get rid of that "spring reverb" but that doesn't help for the resonance. I have also damped...

Hi everyone

I have posted this issue in this forum before, I appreciate all help I got then but the issue is sadly not fully resolved and I would like to try one more time.

I have a fairly new...

It's around 28 % RH, is that considered dry?

Hello everyone

I have 2 EBMM Majesty 2020 that I bought at the end of the summer. Now that winter is here I'm thinking about the dry air and how that can affect the guitars, I would like to avoid...

Hi thank you!

Have you any advice on how to do it?

Hello everyone

I have a EBMM Majesty 2020 model that I own since September. Lately I have noticed white marks on the wood grain on the fretboard. Why have they appeared and how can I remove them?...

Hi!

Thanks for your reply

Curious that you mention the saddle height. Before I got this issue I noticed that the high E-saddle wasn't leveled but a bit inclined. When I leveled the saddle I...

Hi!

Thank you so much for your answer. Could you please be a bit more specific? I'm not that good at following instructions. You mean I should hit the B-string (open string) and lay one of my...

The buzz is at the bridge so it's not fret buzz. I took the guitar to the shop today and what they did was tighten the tremolo arm and put like a piece of sponge under the springs. When I played the...

Thank you, I don't get what could be loose.. can the saddles on the bridge be loose? The screws attached to the springs on the back?

I have noticed now that the resonance is not always present. If...

Hi

Do you mean the screws on the back that are attached to the springs?

Hi! Something on the bass? What do you mean?

Hi!

Thank you for replying, I took the guitar to the guitar shop and it is better now. Apparently, they just needed to grind the nut a bit. Unfortunately a new issue has appeared, certain notes on...

Hi everyone

I have a fairly new EBMM Majesty 2020. Previously I had a small issue with it...

Thanks for your suggestion! Does that affect the tunning stability?

Hi everyone

I have an EBMM Majesty 2020 which I have had since September. The springs make a noise when using the whammy bar that is pretty much described in this video: Electric guitar springs...