Hey thanks beej, I was able to figure that out after a quick check on the Dimarzio site but wasn't certain I was correct so thanks! I have a few pictures of everything as it was before I started, however everything was a bit of a mess from being changed around over the years. On the new pickup I do know which is hot and which is ground, but I'm not sure which is the hot and ground on the switch. I took a guess and got everything wired up but as I toggle between the bridge and neck pickups I get a little of the non active pickup, so in other words if I'm on bridge position I get some of the neck pickup and when on the neck position I'm getting the neck pickup some of the bridge pickup as well. I really wish I had some clear pics of the original wiring at the switch but mostly of the connections to the volume pot. I did make a few sketches of the connections at the switch before starting as I figured that'd be the problem spot but I couldn't make sense of the mess at the volume pot or at least not enough to make any helpful notes. I'm not super experienced at wiring but have been successful at installing EMG's then later a Duncan Custom Custom and Jazz pickup in my Les Paul and I've swapped out pickups for a couple friends so I'm confident I can do it, I just don't get all I need to know from looking at schematic having never learned how to properly read one, although I would like to have a look at one to at least try to get what I need from it. So, I guess if anyone has schematic, pics or even a detailed explanation of the connections it would be extremely appreciated, and I would forever indebted to you not to mention grateful beyond all measure. Thanks bunches!
