Cutlass tremolo

[Aleanimazione1]

Dear All,
writing this post just to receive info.
No worries about anything, just because I also do not use springs as in the pic, but like arrow and also if it could be a problem, it's not a problem for me but...is it ok that the spring above in the last coil touches the tremolo pool board?

Timeline Photos

P.S.:the spring under is not touching the board. It only seems in the picture.

 

[GWDavis28]

If you are talking about the black wire in the picture under the spring I'm pretty sure that's just a ground wire. You should be able to adjust the wire so it's closer to the end of the spring and not right under the spring body.

Hope that helps, Glenn |B)

 

[Aleanimazione1]

Not talking about the wire.
Talking about the spring who touches the perimeter above.
Only the last coil of the spring actually.
Can't revert the pic, but you can see on FB link.
Then, as said, spring where there is a wire, that spring, is far by the perimeter.

 

[DrKev]

I do not think it's a problem and I don't anticipate any issues. If you think it is, you can move the end of the spring to the next position on the claw.

 

[Aleanimazione1]

Think the same.
Actually I already fixed it this way. I always use tremolo with "arrow mode" springs...( <- ).
It was only to have an opinion.

 

[tbonesullivan]

Generally the anchor end of the spring moves very little. I wouldn't worry about it.