Help! help wanted for customize my axis

[ily]

Axis 4 wires originals pickups wanted

I'm a newbie for electrical wiring

i want to have the same routing on my axis than my super sport
i think add replace volume pot by a push pull

if it is impossible maybe just split the humbuckers

i've the original routing (mant thanks to customer service...)

if someone can help me

 

[Jack FFR1846]

Ok, I'm not one to contest CS's schematics, but there's a twisted pair left off from both pickups. This twisted pair is the connection point of the 2 coils. If you get a push-pull pot, you literally put the pot wires on it exactly as they come off the stock pot. Next, you put the twisted pair for one pup on a "hot" post of the push pull switch and the other twisted pair on the other "hot" post. (you need a 2 pole switch). On the center posts of the switch portion, go to ground (just solder to the case of the pot). You now have coil splitting on both pickups. I have my axis setup like this and have it split with the pot pulled up. Most songs I do need lighter stuff up front going to either heavier or a lead later, so I can just whack it down and it goes to humbucker. I left everything else the same.

A regular Axis (or silo spec or Al) are far more complicated and use a 5 way switch.

 

[ily]

Many thanks
this Forum is a great place
i've asked the same thing in a french forum ....no response
i'm really a newbie and because the barrier of language i can't understand all that
you write
if you have again some time for me.. can you give me a shema with all the components
by mp or here as you want ...

many thanks friendly
Jean Marc

 

[Jack FFR1846]

I'm not good with paint editing and for some reason could not get colors.

What I'm showing is what my axis wiring looks like. There are 2 missing wires from each pickup on the schematic. These are green and red. Those are connected together at the switch. You can (hopefully) see those labeled on the switch.

For each of these pairs, they are on the top and bottom of the schematic of the switch. Each of these will then go to a top post on the push-pull pot. One on the left post, the other on the right post.

The middle posts for the push-pull pot are tied together and go to ground (bare wire).

Note that the push pull pot is drawn as seen looking from the back of the guitar. The top 2 posts (now with separate wires) are closest to the back....then the middle. You don't connect anything to the bottom 2. Below the switch part is the pot itself and it follows the stock pot wiring exactly.

I'm hoping that this is a little clearer.

 

[ily]

Many many thanks Jack to have spend a lot of time for me

i love this forum also fo this
i'll tell you if i've green and red wires
i'll see it tomorow

friendly

Jean Marc

 

[ily]

unfortunaly my pickups haven't 4 wires like your schematic
the original schema is good

i can't split these pickups they probably the same on the EVH

i've to post in WTB section to find axis originals pickup with 4 wires

many thanks again to you Jack i keep presciouly you schematic