• Ernie Ball
  • MusicMan
  • Sterling by MusicMan
Ernie Ball Music Man Custom Design Experience

sound clips of what i have

J

J_Alexander

Well-known member
Joined
Sep 10, 2005
Messages
425
most of my olp's dont only one does. this one didnt have the floyd. here is what i run its just a copy from another post. also i have the floyd installed after market so it rests on the body and isnt reseccesed. i think that looks so ugly.

For those that where asking here is what u heard in the audio clips i made. No pics available yet of what i have cause the little tater tot got ahold of the camera but thats ok i still love her. ok this is gonna be long so bare with me. i wont go into settings unless asked later cause this is gonna be long as it is. I used a stock olp mm1 guitar. I have a few of them and only own one good guitar and that is a ebmm evh. i dont play it and keep it at my parents for safe keeping. Its kinda special to me anyways i run a 5150 head that runs into a cheap digital music corp spearker sim cause the reissue palmers are not done yet. from there one output goes to the center dry cabinet which is low in the mix. the other output goes into a switching system i got off e-bay a bradshaw. ok for the effects what i have so far. i run a phaser, flanger and wah. yes the wah is even in the swithcing system. watch the 93 and 95 tour ed turns the wah on and off with the board. also is the everntide. now here is where we get long. i only use the detuner no matter what sound i am getting wether the 93 tour or ou812. what effects the sound is how much detune on both sides, the mix, and how i have them mized at the output stage as far as left and right. you can have both detuners on either side or mixed down the middle etc. you can also add up to 4 per side wow. the two roland sde-3000's. one for each side set differently. thats all i have so far,money lol. now here is where i fall out and the local musci tech comes in. i used to work at a music store and he hooked upo the swithcing system for me but basically all the switching system does is feed the effects a input. then each effect runs there outputs to a minimixer. i do this cause the eventide is stereo and so the rolands will be on each side. i can control the eventide like i said by the mix on the unit so each output is panned hard left and right. from there the two outputs form the mixer go to a peavey power amp and then to the wet cabs. i run a mxr rack noise gate in the effects loop but have ran stuff in the combo effects loop and didnt think it was bad. so thats the run down. hopes its not as confusing for u as it is me. forgot to add i only have some radio shack mics on hand so thats what i use to record. i also forgot. no equing is done in the effects mixer or mic mixer. the only equing is from the 5150 head with fresh jj tubes. ok i think i'm done now.
 
B

bluebullet

Well-known member
Joined
Nov 28, 2004
Messages
231
dude if i owned a evh i would be playing it you aint gonna hurt it and its still going to be worth money ten years from now if you play it or not. that guitar was made to be played you should be enjoying it. just my opinion
 
You must log in or register to reply here.
Papa Het's Signature Guitar Strings
Top Bottom