- Thread starter sikiras
- Start date
Plug it in, switch on, and set a rather low volume. Next, use a toothpick, or similar, to gently wiggle the tiny wires under the saddle. If you get more than very minimal noises you need new saddles installed.
I discovered that if saddles are set reeeally low, too close to the base plate, adjusting intonation can damage those wires. If I want really super low action, to avoid bottoming out the saddles I use a slightly thicker shim to tilt the neck down just a bit.
At some point youll hafta ship it to SLO.
Ben dare don dat about a mag PU.
If you know of any local luthier who is exceptional with electronics, go there first. Shipping to SLO can be over $100. Many luthiers are great with wood and with basic simple wiring but "higher" electronics are rare in geetarz so most luthiers are not into it.
Ok, i had free time to get in it 100%. 1th string i have fixed, it was broken wire under the saddle, around 2 cm under. On the end the input of the 5th. string not work. On pcb are small components and something is't right. I have checked all saddels, all ok!
So the problem is on the electronic!
Does someone knows where to find this?
So the problem is on the electronic!
Does someone knows where to find this?
Any ID markings ? The system is a mix of Fishman and EBMM, and I have no idea who supplys how much of it. You should contact EBMM support.
Last edited:
