Anyone Have a HH AL Wiring Diagram?

[Larry]

I know I'm suppose to contact customer service but it is after hours and I'd really like to get this all wired up tonight. (I've sent an e-mail as well) So please forgive me

I took photos of everything prior to removing the old pickup but unfortunately my data hard drive took a dump earlier this week and I lost the pictures.

Today I received my replacement bridge humbucker from EBMM. When I finally got around to installing it I realized I don't remember where the red wire coming from the bridge pickup goes. All others are accounted for and have been soldered in place.

So if anyone has a wiring diagram for the HH AL could you please post it? Or if anyone knows off hand were the red wire on the bridge pickup goes could you please just tell me (beej?)

Thanks guys,

 

[RocketRalf]

I believe this is the same wiring and switch but I'm not sure maybe you'll recognize it. This comes from the DiMarzio site http://www.dimarzio.com//media/diagrams/E.pdf

 

[Larry]

I believe this is the same wiring and switch but I'm not sure maybe you'll recognize it. This comes from the DiMarzio site http://www.dimarzio.com//media/diagrams/E.pdf

It's close, but unfortunately not the same.

Thanks anyways

 

[beej]

Unfortunately I don't have that one. I assume it's the same scheme as the Axis Super Sports, though (HH, 5 way switching).

If that's the case, red wire goes to the switch in a different manner than that Dimarzio dagram. It's wired to the lugs in position 1, 3, 4, on the opposite side of the switch that the neck p'up is wired to. (Pos 2 is wired to the B&W from that p'up, and to another set of poles on the switch for the splitting.)

Sorry man ... hope that helps.

 

[Larry]

Unfortunately I don't have that one. I assume it's the same scheme as the Axis Super Sports, though (HH, 5 way switching).

If that's the case, red wire goes to the switch in a different manner than that Dimarzio dagram. It's wired to the lugs in position 1, 3, 4, on the opposite side of the switch that the neck p'up is wired to. (Pos 2 is wired to the B&W from that p'up, and to another set of poles on the switch for the splitting.)

Sorry man ... hope that helps.

Thanks beej I think I got it. I'll double check it against the diagram EB sends me tomorrow.