I had gotten a chip in the body that was down to the wood so it stood out. I actually found a nail polish thats virtually dead on to the candy apple finish.
I was hoping just to use that to fill but I notice that nail polish doesn't get rock hard but kinda rubbery. So I'm looking to coat it over with polyurethane and give it a bit of a buff out for a gloss.
Therefore I'm looking to know if EBMM used polyurethane and whether its oil or water based. Local hardware seems just to have oil based. However, if the finish does happen to be water based, would using oil based be an issue? Ding is only about a 1/4" diameter so its not like I'd be using more than a few drops worth literally
Thanks
I was hoping just to use that to fill but I notice that nail polish doesn't get rock hard but kinda rubbery. So I'm looking to coat it over with polyurethane and give it a bit of a buff out for a gloss.
Therefore I'm looking to know if EBMM used polyurethane and whether its oil or water based. Local hardware seems just to have oil based. However, if the finish does happen to be water based, would using oil based be an issue? Ding is only about a 1/4" diameter so its not like I'd be using more than a few drops worth literally
Thanks