Help! Steve Morse Y2D intonation question

[Mordred478]

I just received shipment of my brand new y2d. Could someone please tell me which tool and size tool I need to adjust the intonation? Thank you.

 

[joe web]

you need to adjust a brand new Y2D?
never ever had to a just one of my new EBMM guitars. did you change strings and tuning on it?
btw. is is a tremolo or stoptail version?

 

[Mordred478]

you need to adjust a brand new Y2D?
never ever had to a just one of my new EBMM guitars. did you change strings and tuning on it?
btw. is is a tremolo or stoptail version?

Oh, sorry, it's a stoptail. It is very well setup, but the intonation is just slightly off on two of the strings, and for future reference I will need to know which tool to use. I'm guessing it's just an alan wrench, though I don't know what size.

 

[Pott]

I can't help but think that an Allen wrench would make it tough to intonate a Tune-o-matic! Usually these are intonated with a phillips screwdriver, although of course it will depend on the model and what EBMM uses on theirs.

I'm not sure I understand the question though; if you have the guitar, you can see which tool to use right? Or are you not sure where to adjust it on the TOM?

 

[beej]

Yep, little screwdriver for the intonation screw on the TOM bridge.

 

[Mordred478]

Yep, little screwdriver for the intonation screw on the TOM bridge.

OK, so I need a tiny phillips? Do you know which size? I'm going to look to see if they make angled ones. The reason I couldn't tell is the head of the screw in the bridge is so tiny. Forgive me, I'm old, my eyes are going. ;-)

 

[beej]

I use the largest one in a small jeweler's screwdriver set - think it's a #1 Phillips. They are hard to see!