Question String changing on a JP

[TheRook]

I use one side of a clothespin wrapped in a thin rag or old T-shirt. Works very well and I just keep it in my guitar case.
J

 

[73h Nils]

I use my cleaning cloth.

 

[JPSixx]

I'm a noob and just purchased a JP6 from a collector that was unloading some rigs. I am replacing the strings and using the exact same string/gauge (EB Classic Rock n Roll Slinkys Pure Nickel 9's) he had the guitar setup for.

Well I read this thread and proceeded with the paper towel folded up and placed under the bridge. I removed all the strings to clean the jype that was built up around the frets and used the wipes from EB. Everything was clicking along until the new strings are installed. Remove the paper towel and go to tune the thing and it will not stay in tune and the bridge is pitched up (back is not sitting flush with the body)which leads me to believe the string gauge is heavier but I checked everything I can think of? I checked the neck relief/bow and it seems to be ok.

I'm going to take it in to a pro beccause I have no idea what I'm doing but curious if there are suggestions as to WTF happened when simply changing strings? Thanks for the help and having fun reading all the post on the forum.

SM

 

[fsmith]

It sounds like you went up a string size. It's a very easy fix if you want to try yourself.

Take the trem cover off of the back and tighten the trem claw screws a couple of turns, re-tune and repeat until the bridge is level again.

You'd have to do the same thing is you change your tuning from say standard to e flat.

fred

 

[JPSixx]

It sounds like you went up a string size. It's a very easy fix if you want to try yourself.

Take the trem cover off of the back and loosen the trem claw screws a couple of turns, re-tune and repeat until the bridge is level again.

You'd have to do the same thing is you change your tuning from say standard to e flat.

fred

Thanks Fred but I'm certain the strings are the same gauge but I guess anythings possible. I would want to tighten the trem claw screws to pull the bridge tail down? Thanks for the speedy reply. I hate not being able to do this stuff myself but I guess that will come with expereince.

 

[fsmith]

Yes, tighten the screws to bring it back down to level. I edited my post fix that little error, my coffee hasn't kicked in yet, sorry.

Give it a try, once you figure it out you'll have one less thing to worry about.

Oh yeah, and it make take a few times going back and forth to get it level. Just take your time, it'll get there.

 

[TheShreddinHand]

It's also best to only tighten each screw a 1/4 turn to 1/2 turn at a time and re-tune until you get it level. It will take a little time but you'll get it.

 

[JPSixx]

I think with the help of the board members, I was able to get things dialed in. I'm sure a luthier would really go through it but at least until I take it in FIXED.

The fretboard conditioner from EB works great at removing all the junk and makes bends and vibrato much easier. Thanks for all the help.

Shawn

 

[koogie2k]

I think with the help of the board members, I was able to get things dialed in. I'm sure a luthier would really go through it but at least until I take it in FIXED.

The fretboard conditioner from EB works great at removing all the junk and makes bends and vibrato much easier. Thanks for all the help.

Shawn

Also, when you take it in to a luthier...have them show you how to set it up and what not. I was scared to even adjust the truss rod when I got my first EB...now...second nature and all that jazz.

 

[bonez]

i normally use a sock lol