DuoFuzz
New member
Hi there, I'm a newbie here with a question I hope you guys might be able to help me with.
My brother recently bought a secondhand SUB Silo3 from Ebay. Apparently the seller bought it new but didn't get on with the sound of single coils and decided to sell it on.
It arrived a few days ago and my brother was itching to get a hold of it, so I gave it a quick clean, restrung it, set the trem to float (it had been screwed flat), set the intonation and gave back to my bro without really testing it myself.
He brought it back today saying the humbucker was quiet, so I checked it with a multimeter and sure enough it was reading about 4.90K? I've taken it apart only to find someone has butchered the wiring with a soldering iron. I'm not bothered about chasing the seller for answers but I do need to get this guitar back to it's best.
So this is my question, does anybody have a picture of a complete (unmolested!) wiring harness from a SUB Silo3 or better still, a circuit diagram. I'm specifically looking at how the humbucker is wired in, we think it should coil cut on the bridge/middle position so it cancels hum?
Any help greatly appreciated.
DAN.
My brother recently bought a secondhand SUB Silo3 from Ebay. Apparently the seller bought it new but didn't get on with the sound of single coils and decided to sell it on.
It arrived a few days ago and my brother was itching to get a hold of it, so I gave it a quick clean, restrung it, set the trem to float (it had been screwed flat), set the intonation and gave back to my bro without really testing it myself.
He brought it back today saying the humbucker was quiet, so I checked it with a multimeter and sure enough it was reading about 4.90K? I've taken it apart only to find someone has butchered the wiring with a soldering iron. I'm not bothered about chasing the seller for answers but I do need to get this guitar back to it's best.
So this is my question, does anybody have a picture of a complete (unmolested!) wiring harness from a SUB Silo3 or better still, a circuit diagram. I'm specifically looking at how the humbucker is wired in, we think it should coil cut on the bridge/middle position so it cancels hum?
Any help greatly appreciated.
DAN.
