tip of guitar cable broke

[martin mäder]

hi , i just noticed that the tip of my guitarcable broke and is stuck in my jp15 mono input . is there any possibility to replace the whole input module (1 mono input. 2 stereo input.)
it's impossible to get that piece out of it.any help is much apreciated and thx in advance.

 

[Musikron]

Forceps will get it out.

 

[Sweat]

Hi yes should be able to pull it out, if replacments needed contact Music Man , and it is an output jack

 

[martin mäder]

hi ,it's a closed piece of plastic, no way to get that thing open

Forceps will get it out.

if the tip has the same diameter like the socket, how should i get it out with tweezers ????

 

[tbonesullivan]

if the tip has the same diameter like the socket, how should i get it out with tweezers ????

Oh jeeez. Never had that happen! What brand of cable and what brand of end jack was it?

With many 1/4 plugs, the tip is part of a piece of metal that goes the full length of the plug, so that would be able to be grabbed by a forceps / small pliers.

 

[martin mäder]

it was a very expensif contrik low noise

 

[Fusionman]

You can get the out put jacks from EB but my tech tells me they are directly soldered to a preamp board and difficult to replace. Not sure if it’s true but take the gtr to a tech as he might have a small enough tool to get the job done.

 

[martin mäder]

it's a special module .i (just) need that. i tried to get it out but it slips away everytime.

 

[DrKev]

You can get the out put jacks from EB but my tech tells me they are directly soldered to a preamp board and difficult to replace. Not sure if it’s true but take the gtr to a tech as he might have a small enough tool to get the job done.

No good tech should have difficulty replacing a large component on the circuit board. And yes, good tech may be able to get the piece out too.

 

[V_S]

Have u tried screwing a wood screw into the tip and pull it?