👕 Get New Ernie Ball Merch Now!
  • Ernie Ball
  • Music Man
  • Sterling by Music Man
  • Security notice: Ernie Ball staff will never send you a direct message about a prize or giveaway, and will never ask you to click a link to "claim" anything.
    If you receive a message like that - even from an account whose name looks official - do not click the link. Please report it using the Report link on the message so the moderators can act. A scam campaign impersonating admin accounts was blocked on 29 July 2026; those accounts are banned and their messages have been deleted.
Ernie Ball Music Man Custom Design Experience

Tremolo Arm Fitment

skelt101

skelt101

Well-known member
Joined
May 23, 2022
Messages
47
Location
North Bay Area, CA
Hi folks,
Does anyone know if the modern tremolo arm (without the plastic tip) will fit the Vintage Bridge? Is it as simple as adjusting (i.e. loosening) the set screw under the bridge plate? I'm thinking it would match the look of the solid/block saddles a little better and might be a tad more robust... Thanks in advance!
 
Anyone have experience fitting the 1/4" Diameter Tremolo Arm on the vintage bridge? Anyone? In case it wasn't clear from the original post, the stock bent steel saddles were swapped out for solid brass block saddles. I figured the 1/4" Diameter Tremolo Arm might be a better match visually, and possibly a little more robust when compared to the 3/16" Diameter Tremolo Arm.
 
You must log in or register to reply here.
Classic Rock N Roll Slinky
Back
Top