Wiring JP6 with newer PCB switch?

[Lucas LeCompte]

So im changing out the switch in my JP6 to hopefully finally fix it and I have the newer switch that comes in the newer JPs picture here:

My question is where to I wire the black bridge wire and the white neck pickup where? Can I just use any of the bottom metal circles? On the older switches the wires are go into the PCB itself. The reason im changing it is because I cant use the neck pickup by itself.

 

[beej]

On the square pads. B is black, W is white, etc.

 

[Lucas LeCompte]

I know that, that is for the pickups wires. From the switch itself there is a black wire that runs to the jack, and a white wire that runs to the tone volume pot. Like this:

http://i813.photobucket.com/albums/zz59/drstrangenote/Web/P1420529.jpg

 

[beej]

I don't have one handy, but in general, follow the traces on the other side of the PCB. The ground (Black) will connect to the shield (S) of both pickups. The White will then have a trace going to one of the other solder points.

 

[PeteDuBaldo]

here you go! The red/yellow on the circular pads are used for the push-pull.

Sent using Tapatalk

 

[Lucas LeCompte]

Thanks bro!