• Ernie Ball
  • MusicMan
  • Sterling by MusicMan

GGK

Well-known member
Joined
Mar 11, 2008
Messages
198
Location
Simcoe County, ON
Greetings All, hope someone can offer an opinion. I have been using the WW Fretboard conditioner on my neck and maple fretboard. I have also (2/3 times) wiped the headstock which is the natural color(non matching) After reading the instructions on the bottle last night, it says not to use on treated wood, yikes !!!. I always apply and then wipe off a few minutes later. Does anyone think that I may have done damage to the finish on the headstock? It does not show too much at this point but may be not as shiny as when new. I hope its just bad lighting or P.H.I.G.
Tks
 

Aussie Mark

Well-known member
Joined
Nov 9, 2003
Messages
5,646
Location
Sydney, Australia
Don't sweat it. I doubt the EBMM team would put anything so nasty in the WWs that inadvertently wiping some on places other than the fingerboard would cause damage.
 

paranoid70

Well-known member
Joined
Feb 9, 2007
Messages
2,647
Location
Long Beach, CA
Speaking of which, is the WW Fretboard conditioner still available? I went to a Sam Ash and a GC this weekend, and both stores were out and didn't expect to get more.
 
Top Bottom