👕 Get New Ernie Ball Merch Now!
  • Ernie Ball
  • Music Man
  • Sterling by Music Man
  • Security notice: Ernie Ball staff will never send you a direct message about a prize or giveaway, and will never ask you to click a link to "claim" anything.
    If you receive a message like that - even from an account whose name looks official - do not click the link. Please report it using the Report link on the message so the moderators can act. A scam campaign impersonating admin accounts was blocked on 29 July 2026; those accounts are banned and their messages have been deleted.
Ernie Ball Music Man Custom Design Experience

Help! Axis Wiring Diagram

Jack FFR1846

Jack FFR1846

Well-known member
Joined
Feb 17, 2008
Messages
2,176
Location
Hopkinton, MA
I don't know if my work just blocks it or something, but I have never been able to see any of the wiring diagrams from the Music Man site. After playing some stuff Sunday, I found that my Sublhouette with both hums coilsplit worked absolutely great with some U2'ish delay/reverbish tones that I could not reproduce with my Axis. Luckily, the song following had a long intro and I didn't come in until the solo after a verse and chorus, so had plenty of time to switch to the Axis. But it would be way easier if I could coil split with a push/pull......which is my plan. I mainly need to know how each hum is wired..... I've seen different wiring for hums... Some have both perminantly grounded at one end and some have one grounded and one perminantly to the hot side with a switched ground side.

I've searched (way too much) through threads but have not found what I'm looking for. I don't even need wire colors...I can figure that out easily. Just need to know the above.

thanks
 
The actual wiring diagrams aren't on the site- you've got to get them from CS. But the Axis wiring is the standard HH Dimarzio setup. Green to ground, white & black & to each other, red to wiring harness. So outside coil is green -> white and the inside coil is black -> red.

To get the outside coils, use the white wires as the output (green -> white). And for the inside coils, ground the black wires (black -> red).

Hope that helps.
 
beej said:
The actual wiring diagrams aren't on the site- you've got to get them from CS. But the Axis wiring is the standard HH Dimarzio setup. Green to ground, white & black & to each other, red to wiring harness. So outside coil is green -> white and the inside coil is black -> red.

To get the outside coils, use the white wires as the output (green -> white). And for the inside coils, ground the black wires (black -> red).

Hope that helps.
Click to expand...

Perfect.....exactly what I needed! Thanks.

jack
 
You must log in or register to reply here.
Classic Rock N Roll Slinky
Back
Top