Help! EBMM Sterling Bass Potentiometer question

[mortsnil]

Hello all, I have a 2007 USA made EBMM Sterling bass. The potentiometer needs replacing (the stop is broken, and it does not stop at min/max just keeps spinning). My question is about getting the output jack and board out to install a new pot. The output jack seems to push out ok, but i need to push it in to remove the board and get to the pot to solder it, but the jack does not seem to want to be pushed in (very tight). I have searched high and low for video reference, and cannot find anything. Any help would be greatly appreciated. Stay safe. Thanks!!

 

[Rod Trussbroken]

Hello all, I have a 2007 USA made EBMM Sterling bass. The potentiometer needs replacing (the stop is broken, and it does not stop at min/max just keeps spinning). My question is about getting the output jack and board out to install a new pot. The output jack seems to push out ok, but i need to push it in to remove the board and get to the pot to solder it, but the jack does not seem to want to be pushed in (very tight). I have searched high and low for video reference, and cannot find anything. Any help would be greatly appreciated. Stay safe. Thanks!!

Seek advice here:

[email protected]

 

[mortsnil]

Seek advice here:

[email protected]

I will give it a try, thanks!