👕 Get New Ernie Ball Merch Now!
  • Ernie Ball
  • Music Man
  • Sterling by Music Man
  • Security notice: Ernie Ball staff will never send you a direct message about a prize or giveaway, and will never ask you to click a link to "claim" anything.
    If you receive a message like that - even from an account whose name looks official - do not click the link. Please report it using the Report link on the message so the moderators can act. A scam campaign impersonating admin accounts was blocked on 29 July 2026; those accounts are banned and their messages have been deleted.
John Myung Bongo 4

Help! EBMM Sterling Bass Potentiometer question

M

mortsnil

Member
Joined
Sep 26, 2017
Messages
5
Location
Washington, DC
Hello all, I have a 2007 USA made EBMM Sterling bass. The potentiometer needs replacing (the stop is broken, and it does not stop at min/max just keeps spinning). My question is about getting the output jack and board out to install a new pot. The output jack seems to push out ok, but i need to push it in to remove the board and get to the pot to solder it, but the jack does not seem to want to be pushed in (very tight). I have searched high and low for video reference, and cannot find anything. Any help would be greatly appreciated. Stay safe. Thanks!!
 
mortsnil said:
Hello all, I have a 2007 USA made EBMM Sterling bass. The potentiometer needs replacing (the stop is broken, and it does not stop at min/max just keeps spinning). My question is about getting the output jack and board out to install a new pot. The output jack seems to push out ok, but i need to push it in to remove the board and get to the pot to solder it, but the jack does not seem to want to be pushed in (very tight). I have searched high and low for video reference, and cannot find anything. Any help would be greatly appreciated. Stay safe. Thanks!!
Click to expand...

Seek advice here:

[email protected]
 
You must log in or register to reply here.
Classic Rock N Roll Slinky
Back
Top