I got myself a Majesty a few months back and not long after I had got it I was adjusting the tension screw that keeps the whammy bar from dangling. Next thing I knew the tension screw was gone. I must have screwed it in too much and I think it fell out. I tried searching for it but it was basically like trying to find a needle in a hay stack. Any advice on how to make my whammy bar stay in place? Or does anyone possibly know where I can get a screw of that size to replace it? Earnie Ball doesn’t sell replacements as far as I know. It’s quite frustrating, as I’m sure you could imagine lol.
-
Security notice: Ernie Ball staff will never send you a direct message about a prize or giveaway, and will never ask you to click a link to "claim" anything.
If you receive a message like that - even from an account whose name looks official - do not click the link. Please report it using the Report link on the message so the moderators can act. A scam campaign impersonating admin accounts was blocked on 29 July 2026; those accounts are banned and their messages have been deleted.
Help! Missing whammy bar tension screw on Majesty?
- Thread starter Soryu
- Start date
DrKev
Moderator
I just measured the screw from my Cutlass (I don't know if it's the same or not, but I my guess would be yes).
It's an M3 grub screw, 3 mm wide, 3 mm long, 0.5 mm thread screw pitch, 1.5 mm head.
It's an M3 grub screw, 3 mm wide, 3 mm long, 0.5 mm thread screw pitch, 1.5 mm head.
Awesome thanks for measuring that for me! I did some digging online and it appears that I’ve found the same screw. All the dimensions including the pitch seem to be right. Care to verify for me?
Here’s the link:
Buy M3 x 3mm Cup Point Set / Grub Screws (DIN 916) - Stainless Steel (A2) | Save 95% | 500,000+ Components | Accu(R)
Here’s the link:
Buy M3 x 3mm Cup Point Set / Grub Screws (DIN 916) - Stainless Steel (A2) | Save 95% | 500,000+ Components | Accu(R)
DrKev
Moderator
Perfect!
