-
Security notice: Ernie Ball staff will never send you a direct message about a prize or giveaway, and will never ask you to click a link to "claim" anything.
If you receive a message like that - even from an account whose name looks official - do not click the link. Please report it using the Report link on the message so the moderators can act. A scam campaign impersonating admin accounts was blocked on 29 July 2026; those accounts are banned and their messages have been deleted.
Help! Upgrade jp6 to piezo
- Thread starter Robo123
- Start date
JayDawg
Well-known member
Not unless you go aftermarket and then it will cost quite a bit. You are better off simply buying one with a piezo.
Mordimer
Well-known member
It's extremely hard to buy the piezo saddles (or the whole bridge). But it's not impossible, and not cheap 
Check out this thread on Fractal forum.
Check out this thread on Fractal forum.
beej
Moderator
Wow, that's hardcore. I put a piezo in my Morse, but the install was pretty ghetto by those standards.
joe web
Well-known member
Robo123:
upgrading a JP with piezo is very difficult.
if you want a piezo on your JP, sell it and get the same model with piezo - would be the easiest way i think.
if you like the neck of yours....just keep it and change it with the neck of your piezo JP you will end up buying.
upgrading a JP with piezo is very difficult.
if you want a piezo on your JP, sell it and get the same model with piezo - would be the easiest way i think.
if you like the neck of yours....just keep it and change it with the neck of your piezo JP you will end up buying.
Spudmurphy
Well-known member
Wow, after seeing that thread on the Fractal Audio site - I'd definately save and get the Piezo option - believe me, I have two guitars with Piezo, and I wish they all had them!!
